Gas furnace and heater repair in a Chandler home

Furnace and Heater Repair in Chandler

Quick answer: Chandler heaters fail most often on the first cold nights after sitting idle all summer. Common problems are weak igniters and dirty flame sensors on gas furnaces, stuck reversing valves on heat pumps, and burned-out electric heat strips.

Chandler heaters work a short season. The equipment sits unused from April to November, and that idle time is the main reason for first-cold-night failures: dust on burners and heat strips, dried-out igniters, and heat pumps whose reversing valves have not shifted in months.

Three kinds of heat in Chandler homes

Gas furnaces. Common in homes with natural gas service. Typical problems: a cracked or weak hot-surface igniter, a dirty flame sensor that shuts the burner off after a few seconds, a failed inducer motor, or a clogged condensate trap on high-efficiency models.

Heat pumps. The same outdoor unit that cools in summer runs in reverse to heat. Failures we see: reversing valves stuck in cooling mode, defrost boards that do not trigger, and outdoor units that ice over on the rare nights near freezing. Chandler’s record low is 15°F, and a heat pump needs working backup heat for those nights.

Electric strip heat. Backup coils inside the air handler. A burning smell on the first run each year is usually dust burning off; a smell that persists, tripped breakers, or warm-but-not-hot air are reasons to call.

Before you call

  1. Switch the thermostat to Heat and raise it 5°F above room temperature.
  2. Check the furnace door is fully closed. Many furnaces will not run with the door switch open.
  3. Replace a dirty filter.
  4. For gas furnaces, confirm other gas appliances work.

If you smell gas, leave the house and call Southwest Gas or 911 from outside. Do not try to relight anything.

Carbon monoxide and older furnaces

Many gas furnaces installed during Chandler’s 1990s building boom are now near or past 25 years old. Cracks in heat exchangers can let combustion gases into the airflow. Every gas furnace repair we do includes a combustion and heat exchanger check; our heater maintenance page explains that inspection. Make sure you have working CO alarms near bedrooms.

Repair or replace a Chandler furnace?

Replace when the heat exchanger is cracked, when the furnace is over 20 years old and needs a major part, or when you are already replacing the AC and the indoor unit is the same age. Otherwise, repair. Furnace replacement in a cooling-dominated climate rarely pays for itself on efficiency alone.

Common questions

Why does my furnace smell like burning the first time I turn it on?

Dust burning off the burners or heat strips after months idle. If the smell persists or breakers trip, call for service.

How cold does it get in Chandler?

January nights average 41°F, and the city's record low is 15°F, so heat pumps need working backup heat.

When should a furnace be replaced instead of repaired?

When the heat exchanger is cracked, when the furnace is over 20 years old and needs a major part, or when you are already replacing the AC.

Heater not working on a cold Chandler night? Call 480-719-8109 — a real person in the East Valley answers.

Updated November 2026. Sources: Chandler, Arizona: census and climate data (Wikipedia); City of Chandler Homeowner's Building Permit Manual, rev. April 2026.